Procedures & Techniques Planning & Design > Procedures & Techniques > Finished Frameworks
|
| THE BEGO SYSTEM |
 | |  | |  |
| 2° taper block-out and create ledge for clasp placement | | Relieve saddle areas and create internal finishing line | | Design major connector |
 | |  | |  |
| Apply smooth wax sheet and reinforce connection to mesh retention | | Placement of stipple wax sheet | | External finishing line is created |
 | |  | |  |
| Pontic design of 1st replacement tooth | | Placement of the external finishing line on lower | | Funnel former should be located 10mm above occlusal plane |
|
| SPRUING |
 | |  | |  |
| Placement of sprues supports the alloy flow | Sprue into the thickest portion of the waxed-up design | Reservoirs help eliminate porosity |
 | | According to the textbook, Precision Milling and Partial Denture Constructions by Henning Wulfes
|
